Free shipping on orders over £30
Shop ALL

Published 30 Oct 2024

Cost-Benefit of Insulation Measures

 There’s a general assumption that that the more you pay, the greater your savings will be.

We dug into the costs and payback times of a range of measures recommended by the Energy Saving Trust. Some of the results were quite surprising. All data is from their own website.

 

As a rule, investing in energy saving products is like putting money in the bank. If you pay a bit more for more energy efficient light bulbs for example, you will earn interest on the investment in savings off your electricity bill.  In time this will pay for that additional cost and then put you into profit against the cheaper alternative lightbulb you were tempted to buy at the time.

Measures like double glazing make the home more comfortable, but if you are looking to invest to save then something that takes 125 years to pay for itself is clearly not a profitable investment.

We go on and on about draught-proofing chimneys for good reason. There are around 12 million homes in the UK with open chimneys. If every single one of them was fitted with a chimney draught excluder (or capped off permanently), the country would save 2,760,000 tons of CO₂ and £1,080,000,000 every single year. Sometimes I think I’ve made a mistake with a 0 when I put that figure down but that’s correct. £90 x 12 million = one billion and eighty million pounds.

I do try to make successive governments aware of this but chimney draught-proofing doesn’t seem to be an attention grabber.

Meanwhile, if you’ve got a Chimney Sheep then brilliant, thank you, and keep up the draught-proofing good work. Tell your friends and spread the word. We stock a range of other draught-proofing, insulation and energy saving products now, have you seen the latest additions? We’re pretty pleased with the pipe-lagging. Made of 100% Herdwick wool, it is moth-proofed and plastic free 😊

 

 

 

 

 

Sally Phillips

Inventor of Chimney Sheep

carbon savings
chimney draught excluder
door draught proofing
draught excluder
draught proofing
energy efficiency
energy savings
home improvements
money saving tips
PlanetCare Microfibre Filter Starter Kit

PlanetCare Microfibre Filter Starter Kit

44.00 GBP

How does it work?

This ingenious washing machine microfibre filter kit uses cartridges to physically catch and retain the fibres that come loose when you wash your laundry. Each cartridge will last around 15-20 loads of laundry and is easily replaceable in just a couple of minutes.

Fibre retention is based solely on physical retention with the help of clever patent-pending technology.

You can also send the used cartridges back to us and we'll forward them on to PlanetCare. They will ensure that they are reused or recycled.  This ‘closed loop’ system ensures that there is minimum wastage throughout the whole process.

Something to think about:

Doing the laundry can have a huge environmental impact, whether that be using tonnes of energy running the washing machine and tumble drier - or the pollutants that are released from the products you use. Using a microfiber filter is just one way of reducing that impact. Why not make a few more changes - we've tonnes of handy tips in our blog.

 

What's in the box?

You'll get everything you need to fit your PlanetCare washing machine filter with these handy starter kits, meaning you can get it in place and start catching microfibers straight away.

The Mini Starter Kit includes:

  • 1 housing top with a cup, 1 holder, 4 screws, 1 tube (1.5m), 1 silicone lubricant, 1 counter, and 3 filter replacement cartridges.
  •  3 cartridges. These can last up to 60 washes.

The XL Starter Kit includes:

  • 1 housing top with a cup, 1 holder, 4 screws, 1 tube (1.5m), 1 silicone lubricant, 1 counter, and 3 filter replacement cartridges.
  • 13 cartridges. These can last up to 260 washes.

    Note: All the filter cartridges are 100% recycled and refurbished for use again and again via a closed-loop service.

       

      Is it easy to install?

      The microfiber filter is very easy to install. In fact, for most washing machines this process takes less than 10 minutes. The filters are compatible with all types of washing machines.

      There's actually a handy how-to video and a useful installation guide  you can take a peek at if you need a little bit more guidance.

      It’s a good idea to position it high enough above the floor/surface so the cover can be removed to change the filter and position the device so that it is easy to screw the cover back after each filter change.

      Please note: you will need 13 cm on the side of the washing machine and approx. 60 cm in height clearance so that you will be able to easily unscrew the housing and change the filter comfortably.

      The filter must be placed outside the washing machine on the drain hose. It should not be raised above the height of the drain hose exiting the washing machine. The hose length should be held to a minimum. Raising the filter and a long drain hose will both reduce the efficiency of pumping and filtering and should be avoided.

       

      What are the dimensions of the filter housing?

      The filter housing alone, without any attachments, measures the following:

      • height 325 mm, width (hose attachment direction) 122 mm, and depth 130 mm.

       

      Is the microfiber filter easy to use?

      For the first load, just make sure the filter cover is replaced correctly and screwed tight before using the washing machine. Try a short wash and make sure all connections and covers are fixed and watertight.

      It’s also a good idea to hold the top of the device when replacing the filter cover to avoid putting pressure on the bracket fixings when unscrewing the cover.

      After that, you do not need to do anything until the cartridge is full.

      >Easy!

       

      How does the closed-loop system work?

      When your cartridge is full you can send it back to us directly, simply go onto the delivery website Parcel2Go and produce a label to send the cartridges to us, don't forget to include your order details as we'll refund you the postage cost. We then send these off to PlanetCare who disassemble the cartridge and remove the fibres and filtering medium.  This is done in a controlled environment, ensuring that caught fibres do not pollute water or the environment.

       

      What does Planetcare do with the fibres?

      >At the moment PlanetCare is safely storing the used filtered materials. Once they have sufficient quantity, they will reuse/recycle it all. At the moment they are planning to reuse the materials by converting them into insulation mats. But, they're always on the lookout for viable solutions and will choose the best available option to reuse/ recycle the fibres.

      The waste will never be burned or sent to a landfill!

      The remainder of the cartridge is cleaned, and fitted with a new filtering medium ready to be used again.

      Read More